Boiler pipe high temperature and high pressure steam swivel joint

Swivel Joints | McMaster-Carr

Types Of Steam Pipe Expansion Joints - manufacturer, factory, supplier from China. (Total 24 Products for Types Of Steam Pipe Expansion Joints) Steam Generating Plants Boiler Parts Heat Exchanger. Brand: Jinan Yuanda. Packaging: Steel Frame or Plywood Export Package Depends on …

Learn More

China Boiler Joint, China Boiler Joint Manufacturers and …

Boiler pipe high temperature and high pressure steam swivel joint Tengzhou Hongtian Rotary Joint Factory US $8.00-$70.00 / Set

Learn More

Metal expansion joints - EagleBurgmann

are designed for high temperature and low pressure to accomodate large thermally derived movements, located in a high temperature environment. They pro-vide the flexibility required in e.g. flue gas ducting, boilers, silencers and general exhaust gas piping.

Learn More

Recycling high pressure steam for heating purposes - …

Finally, pipe 17 is installed between low pressure steam boiler 19 and T-joint 23. As can readily be seen, steam generated by low pressure heat boiler 19 may be supplied to the conventional heating equipment 14 and recycled when the corrugator machinery is not in use by opening ball valve 20 and closing ball valves 19 and 21.

Learn More

Water Handbook - Boiler System Failures | SUEZ

In some steam drum designs, water level is extremely critical because the baffling may isolate a generating section of the boiler when the steam drum water level falls below a certain point. Thin-lipped bursts also occur in superheater tubes when steam flow is insufficient, when deposits restrict flow, or when tubes are blocked by water due to a rapid firing rate during boiler start-up.

Learn More

Boiler Temperature - an overview | ScienceDirect Topics

The boiler pressure is 12.5 MPa and temperature is 510°C. The condenser pressure is 50.8 mmHg and temperature is 38.4°C. The regenerator pressure is 132 kPa. Habib et al. (1995) indicated that for maximum efficiency of a single reheat cycle, the reheat pressure should be approximately 19% of the boiler pressure.

Learn More